mgf front sill repair sections
MGF Front Sill Repair Panels Left or Right
Code: FFRHSRP
£ 104.00
(Ex £86.67)
MGF Front Sill Repair Kit left or right
Order in the next Hours Mins and Seconds,
To get your item delivered on Tuesday
Enquire About This Product
A 4 piece repair kit for the front sill corners which are prone to rusting out and MOT failure at the jacking point. The inner sill closing panel is now no longer available and this part resolves this problem. By fitting this front repair section it eliminates the need to buy a complete outer sill which is a much bigger and more expensive job. 
These panels have been developed exclusively by Mike Satur to save our MGF's from being scrapped.. Note these have been made in a limited production run and once sold out they will not be available again.
These new panels will enable a DIY repair as the parts are pre-formed.
Outer section, inner section and a inner sill closing plate incorporating the wheel arch liner fixing point made from 1.2mm steel, a stronger design and sill end closing panel in 1.2 mm steel. A jointing strip to connect with the existing sill section is also included.
Panels are made from zinc coated steel to resist corrosion.Please note final parts may vary from the photos shown.
These panels are hand assembled and formed on my own jigs and fixtures specially made to ensure a good fit.
Use a polyurethane bonding sealer to seal the inner and outer panels from water ingress and clean out this area behind the liner at regular intervals to prevent dirt building up.
NOTE These have to be welded in place and certain health & safety welding precautions associated with zinc coated panels have to be adheared to.
Sold as a 4 part kit only.
 Choose from the options shown either left or right or left and right panels.
Also check out my rear lower wing to sill repair panel.
These have been made as a limited production run.

Watch out for a tutorial on my YouTube channel.